Introduction.īefore You Use the Analyzer. Summary of the Procedure.ĭata Management. Minimize ID Entry Errors.Īpril 2008 Update to the Central Data Station Version 5. Using i-STAT ® Analyzer Customization Features to Result Calibration Modes for the i-STAT 1 Analyzer. 1.2 Staff Only healthcare personnel who have been suitably trained and completed a competency assessment may perform a blood gas analysis using the GEM Premier 5000 analyser. Hematocrit on the i-STAT System.ĪCT Test Result Options: Prewarmed vs. rapidly analyse whole blood samples at the point of care. Receive Data from a Philips Clinical Data Server. BNP measurements can be used as an aid in the diagnosis and assessment of the severity of congestive heart failure. pH value determines the presence of acidosis or alkalosis in the blood. 7.5 to 7.45 (a high pH often points to metabolic or respiratory alkalosis). Installation Guide for the Central Data Station to The i-STAT BNP test is an in vitro diagnostic test for the quantitative measurement of B-type natriuretic peptide (BNP) in whole blood or plasma samples using EDTA as the anticoagulant. In contrast to traditional blood tests, arterial blood gases (ABGs) provide the doctor with values of six different components that must be interpreted as a single result. Hematocrit Determination in the i-STAT SystemĪnd Comparison to Other Methods. Prothrombin Time PT/INR.Ĭardiac Troponin I.Ĭreatine Kinase MB / CK-MB.ī-Type Natriuretic Peptide/BNP.Īnalyzer Coded Messages. In the event that your System Manual does not contain the current configuration, it is recommended that you contact your i-STAT support provider.Īs of April 2008, your i-STAT ®1 System Manual should be configured with the contents as listed below and in the order shown.Ĭover Sheet. Please ensure that the contents of your System Manual are complete and up to date. Windows is a registered trademark of Microsoft Corporation. Precision and PCx are trademarks of Abbott Laboratories. MediSense is a registered trademark of Abbott Laboratories. I-STAT is a registered trademark of Abbott Laboratories. Symbol Technologies Corporation is the owner of US Patent Nos. Patient-side testing is as easy as entering the operator and patient information. features ergonomically designed soft keys for comfort and ease of use. weighs 18 ounces, making it completely portable. Between 16 and 55 kPa (n=44), there was a systematic but small (-0.69+/-0.67 kPa) underestimation of Pa,O2 measured with the i-STAT (p<10(-8)). Below 15 kPa (n=48), the two systems gave nearly identical values, the mean difference was 0.01+/-0.37 kPa. The performance of the analysers depended on the level of PO2. Statistical analysis showed that the differences between analysers did not depend on values of pH or Pa,CO2. Prime Plus combines maintenance-free, component cartridge technology for sensors and reagents with patented, new, maintenance-free, and non. pH and Pa,CO2 values measured with the i-STAT were very close to those obtained with the ABL520, the difference (mean+/-SD) being 0.006+/-0.018 and -0.13+/-0.17 kPa, respectively. Stat Profile Prime Plus is a comprehensive, whole blood critical care analyzer that combines blood gases, electrolytes, metabolites, CO-Oximetry, and 34 calculated results in a simple, compact analyzer. Differences between duplicate measurements were computed for Pa,CO2: (1.2 versus 0.4%), Pa,O2 (1.7 versus 1.1%) and pH (0.06 versus 0.02%), for the i-STAT and ABL520, respectively. Fill syringes for correct blood-to-heparin ratio. Fresh whole blood collected in a plain plastic syringe or in a blood gas syringe labelled for the assays to be performed. All measurements were performed in duplicate by trained technicians from the central hospital laboratory. Fresh whole blood collected in a collection tube with lithium or sodium heparin anticoagulant. Ninety-two samples from the routine blood gas analysis laboratory were chosen according to a wide distribution of partial pressure of carbon dioxide (Pa,CO2), partial pressure oxygen (Pa,O2) and pH and then analysed. The performance of the i-STAT portable clinical analyser for measuring blood gases and pH was evaluated with reference to a conventional blood gas analyser (ABL520 Radiometer).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |